GMC Terrain: Keys and Locks / Automatic Door Locks
The doors will lock automatically when all doors are closed, the ignition is on, and the vehicle is shifted out of P (Park).
If a vehicle door is unlocked and then opened and closed, the doors will lock either when your foot is removed from the brake or the vehicle speed becomes faster than 13 km/h (8 mph).
To unlock the doors:
- Press
on the power door
lock
switch. - Shift into P (Park).
Automatic door locking cannot be disabled. Automatic door unlocking can be programmed. See Vehicle Personalization.
Delayed Locking
This feature delays the actual
locking of the doors until
five seconds after all doors are
closed.
Delayed locking can only be turned
on when the Open Door
Anti-Lockout feature has been
turned off...
Lockout Protection
If the ignition is on or in ACC/
ACCESSORY and the power door
lock switch is pressed with the
driver door open, all the doors will
lock and only the driver door will
unlock...
Other information:
GMC Terrain 2018-2025 Owners Manual: Increasing Speed While Using Cruise Control
If the cruise control system is already activated: Press and hold +RES on the steering wheel until the vehicle accelerates to the desired speed, then release it. To increase the speed in small increments, briefly press +RES. For each press, the vehicle goes about 1 km/h (1 mph) faster...
GMC Terrain 2018-2025 Owners Manual: Battery Load Management, Battery Power Protection and Exterior Lighting Battery Saver
Battery Load Management The vehicle has Electric Power Management (EPM) that estimates the battery's temperature and state of charge. It then adjusts the voltage for best performance and extended life of the battery. When the battery's state of charge is low, the voltage is raised slightly to quickly bring the charge back up...
- Manuals Home
- 2nd Generation Terrain Owners Manual
- 2nd Generation Terrain Service Manual
- Electric Parking Brake
- Wireless Charging
- Hazard Warning Flashers
- New on site
- Most important about car
Categories
Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some action that may be needed to correct a condition. Multiple messages may appear one after another.
The messages that do not require immediate action can be acknowledged and cleared by pressing V. The messages that require immediate action cannot be cleared until that action is performed.
